this post was submitted on 29 May 2024
22 points (100.0% liked)

homelab

6584 readers
1 users here now

founded 4 years ago
MODERATORS
 

I’m a new homelabber, recently bought a SilverStone RM41H08 4U Chassis

My rack is wall mounted and this server is heavy AF to get into place when I need to adjust something.

All the reviews for the branded sliding rails that “work” aka rarely, are terrible.

I’m interested in any ideas people have for maybe DIYing a sliding rail set, or like a better universal rack? Literally anything please hahaha.

I’d even try cabinet rails or something if there’s a good resource on DIYing.

Thanks!

Links for reference: https://www.amazon.com/SilverStone-Technology-Rackmount-Hot-Swappable-RM41-H08-x/dp/B0922FZQFW

https://www.amazon.com/dp/B09B1KZMPN

https://www.amazon.com/ECHOGEAR-15U-Open-Frame-Rack/dp/B07YYJMCNV

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 5 points 5 months ago (3 children)

Full extension rails are probably best going to come from the original vendor as a general principle, rather than attempting to use universal rails.

If you have a wall mounted rack, unless your walls are not drywall, physics is working against you. It's already a pretty intense heavy cantilever, and putting a server in there that can extend past the front edge is only going to make that worse.

If you want to use full extension rails, you should get a rack that can sit squarely on the floor on either feet or appropriately rated casters. You should also make sure your heaviest items are on the bottom ESPECIALLY if you have full extension rails - it will make the rack less likely to overbalance itself and tip over when the server is extended.

[–] [email protected] 2 points 5 months ago

Pesky physics strikes again! Haha. I do have them lay bolted to my basement foundation, so it should support a fair amount of weight… but “should” and “does” are different words for a reason 😂

load more comments (2 replies)