Note the chipped ceramic.. I think only one wasn't cracked
C'mon, some quality time with a wire brush and paint and it's all good! /s
this post was submitted on 21 Sep 2024
72 points (97.4% liked)
Cars - For Car Enthusiasts
3916 readers
41 users here now
About Community
c/Cars is the largest automotive enthusiast community on Lemmy and the fediverse. We're your central hub for vehicle-related discussion, industry news, reviews, projects, DIY guides, advice, stories, and more.
Rules
- Stay respectful to the community, hold civil discussions, even when others hold opinions that may differ from yours.
- This is not an NSFW community, and any such content will not be tolerated.
- Policy, not politics! Policy discussions revolve around the concept; political discussions revolve around the individual, party, association, etc. We only allow POLICY discussions and political discussions should go to c/politics.
- Must be related to cars, anything that does not have connection to cars will be considered spam/irrelevant and is subject to removal.
founded 1 year ago
MODERATORS
Gonna close the gap too
It has been a very long time since I was super into car stuff, but IIRC brown like this is indicative of the plugs being too cold in general, but color is more to do with a short term diagnostic method of tuning.
In this case, from the image angle, it looks like way too large of a gap. You probably need to look into setting your gaps. The new plug is likely closer to a decent gap. The older plug looks like it was intended to be gapped manually but never was.
Also, limited by the angle of the image somewhat, but it appears that the plug was only firing from a single hotspot. Those pointy corners of the tab are intended to focus the spark into one area for a more reliable ignition timing and flame front propagation. However, this engineering methodology tends to cause a deposition of material at this point location over time. This plug clearly has a considerable build up of material around this hotspot. That build up could have caused the plug to fire cold and late in the cycle thus building up the brown deposit on the ceramic insulator.
The new plug is of a better design for long term use without service. The rounded sharp edges (on both sides of the spark) will allow the spark to propagate from more places along that edge after any specific hotspot builds up resistance. It has less predictable flame front control, but this does not matter on most factory vehicles, just racing and motorsports really.
The old plug has a large gap and is rounded from usage. This is normal.
Yea, it's the wear that makes the gap larger. I've seen this many times (we keep our cars forever).
174k on that plug would be pretty good going. Iโve seen them under 150k where the negative has worn down to the bend.
174,000k on that spark plug and it still looks that good? I want to know what brand, because every spark plug I've ever owned at 100,000k does not look nearly that good.
Marshmallow, perfectly toasted marshmallow.
174k and it didn't break apart trying to get it out. You are quite lucky.