homeassistant

11993 readers

35 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 1 year ago

MODERATORS

[email protected]

Trying to use a Shelly Plus 1PM to monitor my pool's SWG, but the switch function isn't working (lemmy.world)

submitted 1 year ago by [email protected] to c/[email protected]

9 comments fedilink hide all child comments

Right now if the pool timer is switched off, the SWG stays on. Likewise, if I switch the Shelly off and switch the timer on, the SWG stays off (and the pump turns on). Checking the SW terminal with a voltage sensor, it is hot when the pool timer is switched on, and dead when switched off. The workaround right now is the setting the schedule feature to closely match what the timer is doing.

Any ideas?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 year ago* (last edited 1 year ago) (1 children)

Switch mode is set to ‘Follow’. I do see now that the page is showing the input as ‘OFF’ where previously it wasn’t changing from ‘ON.’ Perhaps some leaking current or a massive delay.

More testing tomorrow!

Edit: Current leak confirmed. :( Randomly went back to ON and switched it on. But at least I know it’s not a Shelly issue?

[–] [email protected] 1 points 1 year ago

Lots of reports out there of people having current leak issues when doing anything more than the usual light switch configuration. Personally, I'd just put a dumb power meter on it and leave the chlorinator hooked up to the pump line.