Small coffee shop in Alba, Italy
this post was submitted on 28 Oct 2023
380 points (97.3% liked)
Coffee
8355 readers
1 users here now
☕ - The hot beverage that powers the world!
Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!
Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I personally find the Moka pot to be more consistent for me personally, as long as you keep the temperature from getting to high and take it off the heat before the bubbly too hot water comes out it's bang on. With an Aeropress I could never figure out how to make it well consistently.
The Aeropress is dead simple: I haven't found much of a difference, taste wise, when using 14 to 18.5 grams of beans. I usually stick with 18.5g at a relatively coarse grind size (65 on my DF64 if that means anything to you, it goes from 100 which is really coarse to 1 which is extremely fine, like for Turkish Coffee, well below espresso, which is usually in the 12-15 range), grind my beans fresh, and use boiling water since I largely drink medium or light roasts. I let it brew for 2.5 minutes and it's damn good every time. I've even let it brew for like 7 minutes when I forgot to set a timer, thinking it was going to be disgusting swill and it was only a bit bolder than what I was used to. It's pretty hard to mess up an Aeropress brew IMO.
If you keep on using your moka pot that way, you can get great coffee every time. You just need to keep an eye on it. Unfortunately, it’s very easy to screw it up, whereas with the areropress screwing it up requires borderline criminal negligence. As long as you weigh the grinds and water, AP produces very consistent results for me. If you happen to be an experienced taster, you can probably notice if the grind size, temperature or extraction time is a little bit off.
I’ve tried a bunch of side-by-side comparisons and I can tell you that I’m not quite that experienced, so I don’t need to worry about the finer details that much. As long as both weights are within a reasonable range, the coffee ends up being really good every time.