Hi all, I’m trying to run a Ethernet cable to my home office in a house built in the 60s. This connection is unlabeled and I’m not sure what it is. Can I somehow replace it with an Ethernet cable? I’m new to all of this and did some poking around in the sub but I’m not really sure what I’m looking at or what I’m in for. I don’t have any coaxial cables that I can utilize (unless they are hidden behind a wall? Any easy way to find those?). Thank you.
Well, there was an element of that involved, but they also tended to just throw tons of spare pairs in with an idea that some future tech might use them. At the time PCM based circuit switched data was being developed and envisioned to launch as some point. It would ultimately launch as ISDN in the 1980s.
Local ISDN S-Bus wiring usually ran with two pairs and an additional two pairs for power. It was rarely deployed in homes, other than in a few European countries, but it (or proprietary versions of it) were commonly used for office telephone systems.
Rapid advances in multiplexing in the 90s saw DSL emerge as the most common way of getting fast data into homes and small offices. That only required a single pair and then telcos shifted to fibre to home. So it’s all redundant.
You’ll see plenty of home phone installations that used CAT3 or even CAT5 in the later days of PSTN with tons of spare pairs.