VoronDesign

305 readers

1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago

MODERATORS

[email protected]

0.2 owners - Bed heat time? (lemmy.world)

submitted 5 months ago by [email protected] to c/[email protected]

6 comments fedilink hide all child comments

0.2 owners, could you tell me how long your bed takes to heat from room temperature to 60 and 100°C please 😁

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 4 months ago (1 children)

I don't think anyone has a v0.2 in this instance 😅 Thanks for going out of your way to answer my question, even though you can't 🤣

I'm wanting it because I realise I do a lot of very small parts and I often want to iterate on them quickly, so a fast bed heat would be quite nice. I currently always heat soak for bed meshes and such, but I haven't found it necessary for prints - they're usually not that big though 🤷‍♂️

Do you know where I can find that documentation on max heating?

[–] [email protected] 2 points 4 months ago (1 children)

For the v2 it's actually in the sample klipper config under heater_bed as comments.

Totally understand, I'm thinking about building a small trident or 0.2 at some point for the same reason, I very rarely use the entire bed area of the 2.4

[–] [email protected] 1 points 4 months ago

I can see a bit about the solid state relay overheating with too much power, but that's not the bed. Have I missed something or have you possibly misread something yourself 🤪

I don't know how small you are thinking, but if it's V0 size, make sure you've seen the "crucible" on 3dprintersforants, it looks cool 😎