Faster to (dumb) switch them separately.
Home Networking
A community to help people learn, install, set up or troubleshoot their home network equipment and solutions.
Rules
- Please stay on topic.
- Please use the search function to look for keywords related to what you want to ask before posting since most common issues have been answered.
- No Ads. This community is for support and discussion. Ads and self promotion are not welcome here.
- No product reviews or announcements. If you have a question about a product, be specific about what you want to know.
- Be civil. Don't be a jerk. Not being a jerk is surprisingly easy.
- No URL shorteners. URL shorteners tend to hide the real use of a link. For this reason, please use normal links, even if they're long.
- No affiliate links.
- No gatekeeping. With profession shall come professionalism. Extend help without judging others for their ignorance. The same goes for downvoting of comments or posts for "stupid questions" or not being as knowledgeable as others.
Yes via vlan trunk
It can be done with VLANs, but I don't recommend it.
Much better to put the router in the basement between the ONT and Switch 1, and an AP for WiFi in the office.
Do the basement and office have coax available? If so, MoCA might work for you. Pass the LAN traffic over MoCA into a switch in the basement.
Yes, with VLANs and managed switches. But if you don't already have managed switches, you'd have to replace both of them. By far the cheapest solution is to put a small wired router (e.g. I've owned a TPLINK ER605 that would work, performing routing and DHCP) between the ONT and SW1, and then reconfigure the WiFi-Router to turn off the router and DHCP functions, leaving the internal switch functional and allowing the WiFi to serve as an Access Point.
This setup doesn't make any sense. You need to route all traffic from the ONT into a router, and then into switches and access points.
Any other topography is unnecessarily complicated and a losing game.
Why can't you connect directly to wifi router instead of using SW 2? That extra and unnecessary.
You simply have to get two managed switches that support VLANs and setup a trunk port to connect them. That's not difficult at all.
This is what I was wondering. Thanks!
This is old, but the diagrams in the first answer show you how to tag the ports to get the same setup as you described above:
https://superuser.com/questions/789294/can-i-send-a-wan-and-lan-connection-over-the-same-cable
Thanks! Does this create any risk for network issues that I should be aware of?
As others have said, this can absolutely be done, it's commonly referred to as a router on a stick if you're trying to do research.
Very easy if both switches are L2 managed. Ont to switch1 “wan vlan ” Switch1 to rest of house “lan vlan” Switch1 to switch2 “trunk” Switch2 to router wan port “wan vlan” Switch2 to router lan port “lan vlan”
Keep your management traffic off the wan vlan.
Technically you could through VLANs, but I would just put your router in the basement near the point of entry, and then put an Access Point where your current router is now.