Run the ethernet cable, add a switch to connect your two machines over 2 more wires and you will never experience internet problems, except perhaps with your phone.
heysoundude
joined 1 year ago
Do you have an old router kicking around? If you do, it’s possible it may be reconfigured: Asus calls it a Media Bridge, where it becomes a wired switch with a wireless connection to a router. I did this for an old laptop whose wifi card died, and the user is thrilled with the speeds being ~3x what they were. No holes or fishing cable through walls required.
The most cost effective way to get consistent and fast internet is over a wire. My rule is that if it doesn’t move, and if it has an ethernet port, it gets a wired connection. TVs, gaming Consoles, the laptop that lives on a desk/table…this stuff. Then the stuff that does move or can’t be wired to a switch can have the wireless bandwidth it needs. So, OP, you need a box of Cat5e spec UTP cable, a bunch of ends and the tool to put them on the cables you make, and a switch or two with 8 or more ports each. Next is to find wireless access points that are wifi6 and capable of covering your home. 2000sqft can usually be covered by a single unit of any top tier routers from most manufacturers. I’m partial to Asus for home use. After this, it’s a matter of configuration. If you have many neighbours, turn off the 2.4GHz band radio (if possible for the wireless-only clients). If you don’t have wifi coverage where you need it, add another WAP (NOT a mesh node) - it’ll be easy to deploy with a wired backbone infrastructure already in place.