this post was submitted on 04 Dec 2023
299 points (99.3% liked)

HistoryPorn

4803 readers
130 users here now

If you would like to become a mod in this community, kindly PM the mod.

Relive the Past in Jaw-Dropping Detail!

HistoryPorn is for photographs (or, if it can be found, film) of the past, recent or distant! Give us a little snapshot of history!

Rules

  1. Be respectful and inclusive.
  2. No harassment, hate speech, or trolling.
  3. Engage in constructive discussions.
  4. Share relevant content.
  5. Follow guidelines and moderators' instructions.
  6. Use appropriate language and tone.
  7. Report violations.
  8. Foster a continuous learning environment.
  9. No genocide or atrocity denialism.

Pictures of old artifacts and museum pieces should go to History Artifacts

Illustrations and paintings should go to History Drawings

Related Communities:

Military Porn

Forgotten Weapons

founded 1 year ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 2 points 11 months ago* (last edited 11 months ago) (1 children)

Wouldn't that introduce a pretty big layer that can wear down? Any sort of fully opaque cover would have to be flexible to adapt to the road and I can't think of a material that isn't going to wear down from that, and at that point you're just back to inflated tires with extra steps, so you might as well use regular inflated tires.

[–] [email protected] 0 points 11 months ago (2 children)

Well no because you can just get that part replaced as often as you replace your tires normally

[–] [email protected] 2 points 11 months ago

Just covering hard base with some material will make it wear down much faster due to the way pressures are distibuted.

Pressurized tires are much better in this case, allowing for a better distribution of mechanical stress and less wear and tear.

[–] [email protected] 1 points 11 months ago (1 children)

Your original intent was to not need to replace tyres. If you still need to replace other parts just as often, you haven't really improved on the problem.

[–] [email protected] 1 points 11 months ago (1 children)

My intent was to not need to get them inflated every few months

[–] [email protected] 1 points 11 months ago

Again it comes back to weight and balance.

You've taken a tire that was previously filled with very light air and filled it with rubber or plastic lattice.

So not only will the tire ride worse and wear faster due to weight but it will be more expensive to replace more often.

You will always have to inflate your tires every few months, because even if the amount of air inside the tire never changes, the outside air temperature will.

10 degrees Fahrenheit for every 1 PSI in the tire is the rule of thumb.