this post was submitted on 04 Dec 2023
299 points (99.3% liked)
HistoryPorn
4803 readers
130 users here now
If you would like to become a mod in this community, kindly PM the mod.
Relive the Past in Jaw-Dropping Detail!
HistoryPorn is for photographs (or, if it can be found, film) of the past, recent or distant! Give us a little snapshot of history!
Rules
- Be respectful and inclusive.
- No harassment, hate speech, or trolling.
- Engage in constructive discussions.
- Share relevant content.
- Follow guidelines and moderators' instructions.
- Use appropriate language and tone.
- Report violations.
- Foster a continuous learning environment.
- No genocide or atrocity denialism.
Pictures of old artifacts and museum pieces should go to History Artifacts
Illustrations and paintings should go to History Drawings
Related Communities:
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Well no because you can just get that part replaced as often as you replace your tires normally
Just covering hard base with some material will make it wear down much faster due to the way pressures are distibuted.
Pressurized tires are much better in this case, allowing for a better distribution of mechanical stress and less wear and tear.
Your original intent was to not need to replace tyres. If you still need to replace other parts just as often, you haven't really improved on the problem.
My intent was to not need to get them inflated every few months
Again it comes back to weight and balance.
You've taken a tire that was previously filled with very light air and filled it with rubber or plastic lattice.
So not only will the tire ride worse and wear faster due to weight but it will be more expensive to replace more often.
You will always have to inflate your tires every few months, because even if the amount of air inside the tire never changes, the outside air temperature will.
10 degrees Fahrenheit for every 1 PSI in the tire is the rule of thumb.